Sharp SRT-8040 - Manual (Page 32)

RECORDING USING AN EXTERNAL TIMER
INPUT
Recording can be controlled by an external start/stop
signal input at the EXT TIMER IN terminal.
While there is input at the EXT TIMER IN terminal, the
external input indicator “E” will light on the digital display
and the input will be recorded. Recording will stop when
there are no more input signals.
Example 3: To record using the signal input at the
EXT TIMER IN terminal, in 24-hour
mode.
œ Follow the Before starting steps, under “NORMAL
RECORDING”.
NOTE:
œ External timer input recording can only be set on the
“EXT” line of the (TIMER SET) menu.
1 Follow steps 1 and 2 under “PROGRAM TIMER
RECORDING” on page 27.
2 Turn the JOG dial until the “EXT” line is highlighted,
then turn the SHUTTLE ring clockwise.
3 Turn the JOG dial to select the recording speed
mode (ex: 24), then turn the SHUTTLE ring
clockwise.
4 Turn the JOG dial to select “Y”.
<TIMER@SET>
WEEK@@START@@STOP@@SPD
SUN@@@--:--@--:--@@---@N
MON@@@--:--@--:--@@---@N
TUE@@@--:--@--:--@@---@N
WED@@@--:--@--:--@@---@N
THU@@@--:--@--:--@@---@N
FRI@@@--:--@--:--@@---@N
SAT@@@--:--@--:--@@---@N
DAILY@--:--@--:--@@---@N
EXT@@@*****@*****@@@24@Y
5 Press the MENU EXIT button.
6 Press the TIMER button.
NOTES:
œ Alarm recording is not possible using this function.
œ Alarm recording reset function is not possible using
this function.
œ Other timer recordings using the standard procedure
can also be programmed.
RF4QR/NA (SRT-8960 GB) Wed. May, 08/2002
English
31