Sharp SRT-8040 - Manual (Page 53)

SPECIFICATIONS
General Specifications
Video head system Dual-azimuth 4-head rotating helical scanning system:
Dual azimuth 2-head for record and standard playback
Dual azimuth 4-head for forward picture search, reverse picture search
and still mode
Audio recording In 8-, 24- and 40-hour modes (when using T-160 tape)
In 6-, 18- and 30-hour modes (when using T-120 tape)
Tape speed 11.12 mm /sec (8-hour mode)
Specified video cassette tape VHS 1/2 inch video cassette tape
Recording/playback time (SRT-8960 only) 8, 24, 40, 64, 96, 128, 160, 224, 320, 480, 640, 960 and 1280 hours (when
using T-160 tape)
6, 18, 30, 48, 72, 96, 120, 168, 240, 360, 480, 720 and 960 hours (when
using T-120 tape)
Recording/playback time (SRT-8168 only) 8, 24, 40, 64, 96, 128, 160 and 224 hours (when using T-160 tape)
6, 18, 30, 48, 72, 96, 120 and 168 hours (when using T-120 tape)
Recording/playback time (SRT-8040 only) 8, 24 and 40 hours (when using T-160 tape)
6, 18 and 30 hours (when using T-120 tape)
Fast forward/rewind time approximately 2 minutes 35 seconds (when using T-160 tape)
approximately 2 minutes (when using T-120 tape)
Television system NTSC color TV system
Video
Recording method Luminance signal: FM recording
Chrominance signal: Down-converted direct recording
Video input 1 V(p-p), BNC, 75
Ω
, unbalanced
Video output 1 V(p-p), BNC, 75 Ω , unbalanced
Horizontal resolution Black & white mode 350 line or more
Color mode 300 line or more
Audio
Input –8 dBs, RCA pin jack, 27 k Ω , unbalanced
Output –8 dBs, RCA pin jack, 600
Ω
, unbalanced
Connectors
Alarm (1 shot) input No voltage, make-contact switch input (Low input 100ms or more,
Normally 5 V)
Control input Key code (pulse signal) (Normally 5 V)
Series input No voltage, make-contact switch input (Low input 1s or more, Normally 5 V)
Ext timer (alarm reset) input No voltage, make-contact switch input (Low input 100ms or more,
Normally 5 V)
Common 0 V (GND)
Warning output Open collector Max. 500 mA (Active Low 0 V, Normally open)
Control output Key code (pulse signal) (Normally 5 V)
Tape end output Open collector Max. 50 mA (Active Low 0 V, Normally open)
Timer output DC 5 V, 5.7k Ω , (Low output)
Switch output Pulse signal (Normally 5 V)
Remote control input 3.5 mm mini jack
RF4QR/NA (SRT-8960 GB) Wed. May, 08/2002
52
English