Sanyo PLC-WXU300K - Manual (Page 37)

37
Choose Video or S-video by pressing the INPUT button on
the top control or the VIDEO button or the S-video button on
the remote control.
Before using INPUT button, correct input source should be
selected through menu operation as described below.
1

Input Menu
Input Source Selection (Video, S-video)
Video Input
Direct Operation
Menu Operation
When video input signal is connected to the
VIDEO jack, select Video.
Video
When video input signal is connected to the S-
VIDEO jack, select S-video.
S-video
Note:
When the Input Search function is set to On1 or On in
the Auto setup function, the input signal will be searched
automatically (p.45).
Top Control
INPUT button
Remote Control
VIDEO button
Press the MENU button to display the On-Screen
Menu. Use the Point ▲▼ buttons to select Input and
then press the Point ► or the SELECT button.
Use the Point ▲▼ buttons to select either Video or
S-video
and then press the SELECT button.
S-VIDEO button
Video
S-video
 COMPUTER  can not be selected when using the COMPUTER IN 2/
MONITOR OUT terminal as MONITOR OUT output.
Computer 1
HDMI
Computer  
S-video
Video