Sony PDW-1500 - Manual (Page 63)

Chap
te
r 6
Men
u
s
63
6-3 Extended Menu
626 TC MODE Make selections relating to the time code and the internal time code
generator.
int preset: The initial value of the time code produced by the internal time
code generator can be preset by a control panel operation or by
remote control from a device connected to the REMOTE connector.
int regen: The internal time code generator is synchronized to the
playback time code read by the internal time code reader.
ext regen: The internal time code generator is synchronized to the
external time code input to the TIME CODE IN connector
a)
or the
VITC time code included in the input video signal b) .
rp 188 regen: The internal time code generator is synchronized to the
RP-188 time code data.
ext preset: The initial value of the external time code input to the TIME
CODE IN connector
a)
or the VITC time code included in the input
video signal
b)
can be preset by a control panel operation or by
remote control from a device connected to the REMOTE connector.
a) When “tc” is set in menu item 629.
b) When “vitc” is set in menu item 629.
627 RUN MODE Select one of the following running modes for the internal time code
generator.
free run: The time code continues to increase as long as the unit is
powered on, regardless of the unit's operating mode.
rec run: Time code increases during recording only.
If you select this mode, you should also set item 626 to “int preset.”
628 DF MODE Select either drop-frame mode or non-drop frame mode for the time code
generator and the counter (when 525(U) or 525(J)-line mode is selected).
on (df): Drop-frame mode
off (ndf): Non-drop frame mode
Note
When “int regen,” “ext regen” or “rp 188 regen” is selected in menu item
626, the internal time code generator is synchronized to the playback
time code, external time code, or RP-188 time code. Therefore, this menu
setting does not work.
629 TC SELECT Select the type of time code to display in the time data display.
vitc: Display VITC.
tc: Display TC.
651 UMID SDI OUTPUT Select whether to output UMID in the VANC of the SDI output.
off: Do not output.
on: Output.
652 UMID SDI VANC LINE Select the line in which UMID is output when menu item 651 is set to “on.”
12 H, 13H, 15H ... 17 H ... 19 H (in 525(U)/525(J)-line modes): Select
any line from 12 to 19 (excluding line 14).
9 H, 10H, 12H ... 17 H, 18 H (in 625-line mode): Select any line from 9 to
18 (excluding line 11).
Menu items in the 600s, relating to the time code and metadata
Item number Item name Settings
Menu items in the 700s, relating to video control
Item number Item name Settings
701 SELECTION OF VIDEO/SYNC
DELAY An E-E video signal is output delayed with respect to the video input signal
by the time for video circuit processing.
With this item, select whether or not to delay the sync signal attached to
the output video signal by an amount corresponding to the video signal
delay.
sync: Delay the sync signal by the corresponding amount before attaching
it.
video: Attach a sync signal with the same timing as the input signal.