Sony PDW-1500 - Manual (Page 65)

Chap
te
r 6
Men
u
s
65
6-3 Extended Menu
Menu items in the 700s, relating to video control
(Items 715 to 720: Settings for controlling the video processing system according to the menu settings.)
Item number Item name Settings
713 VIDEO SETUP REFERENCE Select whether to remove the setup (7.5%) from the input analog video
signals and whether to add the setup (7.5%) to the output analog video
signals (when 525(U) or 525(J)-line mode is selected).
Sub-item
1 INPUT LEVEL Whether to remove the setup from the input.
0.0%: Do not remove.
7.5%: Remove.
The default settings for each line mode are as follows:
525(U)-line mode: 7.5%
525(J)-line mode: 0.0%
2 OUTPUT LEVEL Whether to add the setup to the output.
0.0%: Do not add.
7.5%: Add.
The default settings for each line mode are as follows:
525(U)-line mode: 7.5%
525(J)-line mode: 0.0%
715 VIDEO GAIN CONTROL Adjust the video output level.
–512 to 0 to 511
716 CHROMA GAIN CONTROL Adjust the chroma output level.
–512 to 0 to 511
717 CHROMA PHASE CONTROL Adjust the chroma phase.
–128 to 0 to 127
718 SETUP LEVEL (525(U)/525(J)-line
modes)/BLACK LEVEL (625-line
mode) Adjust the setup level (black level).
–512 to 0 to 511
719 SYSTEM PHASE SYNC Adjust the output signal sync phase.
–128 to 0 to 127
720 SYSTEM PHASE SC Adjust the output signal subcarrier phase.
0 to 511
723 INPUT VIDEO BLANK Switch blanking on or off for individual lines in the vertical blanking
interval of an input video signal. The Y/C signal and odd/even fields are
blanked simultaneously.
A signal with blanking carried out according to this setting is recorded.
Sub-item
0 ALL LINE - - -: Specify the blanking for each line separately.
blnk: Regardless of the setting of other sub-items, blank all lines which
can be specified in this menu item.
thru: Regardless of the setting of other sub-items, switch off blanking for
all lines which can be specified in this menu item.
In 525(U)/
525(J)-line
modes 12 ... 20 LINE 12 ... LINE 20 Specify blanking for lines 12 to 20.
blnk: Carry out blanking.
thru: Switch off blanking.
In 625-line
mode 9 ... 22 LINE 9, 322 ...
LINE 22, 335 Specify blanking for lines 9 to 22.
blnk: Carry out blanking.
thru: Switch off blanking.
726 H BLANKING WIDTH Select the horizontal blanking width of the video output signal.
narrow: Digital blanking (narrow)
wide: Analog blanking (wide)
When “wide” is selected, the horizontal blanking width complies with
RS170A, and normally the blanking is widened and the image becomes
narrower. It is recommended to select “narrow” at the editing stage, then
later, for broadcast transmission to select “wide,” to output a signal
conforming to the standard. Note, however, that “narrow” has to be
always selected for SDI signals.
728 OUTPUT SCH PHASE Set the subcarrier H phase.
–512 to 0 to 511