Sanyo PDG-DHT8000L - Manual (Page 47)

47
Auto picture control
Use the Point 7 8 buttons to select the desired Auto picture
control position (Off, L1 or L2).
Off . . . . Auto picture control OFF position.
L1 . . . . . Auto picture control LEVEL 1 position.
L2 . . . . . Auto picture control LEVEL 2 position.
Clear the check mark if you do not want to apply the
adjusted color data; select the check mark and then press
the SELECT button. The check mark disappears.
Return to the COLOR MANAGEMENT POINTER. (If you
press the MENU button on the side control or the remote
control, it returns to the COLOR MANAGEMENT POINTER
and you will need to reselect and readjust the color.)
Return to the IMAGE ADJUST Menu. Any settings that
have been changed will not be stored. To store the
changed settings, be sure to select “LIST” and go to the
COLOR MANAGEMENT LIST.
LIST MODE
Return to the COLOR SELECTION mode so that you can
readjust the setting for the color in that line. (This option is
not available if the check mark is cleared.)
Select the DEL box if you want to delete the adjusted
data. Press the SELECT button and a confirmation box
appears and then select [Yes].
Delete all the data in the list. Press the SELECT button and
a confirmation box appears and then select [Yes].
The same function as stated above.
Level and phase
adjustment palette.
Gamma
adjustment palette.
Color temp .
Use the Point 7 8 buttons to select the desired Color temp.
level (XLow, Low, Mid, or High).
COLOR M .
MENU
COLOR PALETTE
DEL
ALL DEL
COLOR M .
LIST COLOR M . MENU
COLOR PALETTE
DEL
ALL DEL MENU COLOR M .
COLOR SELECTION MODE
LIST MODE
COLOR SELECTION MODE (continued)
In the COLOR MANAGEMENT LIST, the adjusted color
data are checkmarked. You can decide whether or not to
apply the adjusted color data in the list to the projected
image (see below).
4
MENU
The same function as stated above.
Picture Image
BrilliantColor
Set to ‘On‘ to achieve a wider range of color reproduction and
increase the brightness of the halftone. Use the Point 7 8
buttons to select from (Off/On).
✔ Note:
• Color temp. will be displayed in grayout when
‘Dynamic‘ is selected in the Image level
selection (pp.39, 43).