Sanyo PDG-DHT8000L - Manual (Page 84)

84
Appendix
On-Board Optional Interface Board
Input1 Input2
Dsub
-DVI
Component
-S-video
SDI
Analog
PC
Scart Digit
al
Analog
PC
Component
Video/ S-V
ideo Analog
PC
Scart Digit
al
Analog
PC
Component
Video/ S-video Digit
al
On-Board
Input1
Analog PC o o o o o o o o o o o
Scart o o o - - - o - - - o
Digital o o o o o o - - o o o -
On-Board
Input2
Analog PC o o o o o o o o o o
Component o o o o o o o o o o
Video/
S-Video
o - o - - o - - - o
List of Picture in Picture
o : Picture in Picture combinations are enabled
- : Picture in Picture combinations are disabled
✔ Note:
• As for Input 3 and Input 4, combination of digital signals for Main picture and Sub picture is not available.
• When the input signal(s) is/are incompatible, X mark will be displayed on the Main/Sub picture.
• Depending on the frequency or signal type of PC/AV input, the display resolution may be lowered or images may not be
displayed on the Main/Sub picture.
<Display resolution is lowered when;>
• Inputting PC analog signals: Between 100-160 MHz
• Inputting AV analog signals: 1080p
<Images are not displayed and X mark appears when;>
• Inputting PC analog signals: More than 160MHz
• Inputting PC digital signals: More than 100MHz
• Inputting AV digital signals: 1080p
When using the optional board (DVI) “POA-AMDADI”, refer to the chart on the previous page.
When using the optional board (Dual SDI) “POA-AMD17SDID”, refer to the chart below.
Supported Signal Format for Optional Board
ON-SCREEN
DISPLAy
RESOLUTION H-Freq .(kHz) V-Freq .(Hz)
1035i
1920x1035
(Interlace)
33.750 60.000
1080i
1920x1080
(Interlace)
33.750 60.000
1920x1080
(Interlace)
28.125 50.000
720p/60 1280x720 45.000 60.000
720p/50 1280x720 37.500 50.000
ON-SCREEN
DISPLAy
RESOLUTION H-Freq .(kHz) V-Freq .(Hz)
1080psf/30 1920x1080 33.750 60.000
1080psf/25 1920x1080 28.125 50.000
1080psf/24 1920x1080 27.000 48.000
1080p/30 1920x1080 33.750 30.000
1080p/25 1920x1080 28.125 25.000
1080p/24 1920x1080 27.000 24.000