Sony STR-DH710 - Manual (Page 65)

65 GB
S-A
IR Oper
ations
Changing the channel
for better sound
transmission
If you use multiple wireless systems which
sharing the 2.4 GHz band, such as wireless
LAN or Bluetooth, the transmission of S-AIR
products or other wireless systems may be
unstable. In this case, the transmission may be
improved by changing the following “RF
SETUP” setting.
1
Press AMP MENU.
2
Press V/v repeatedly to select
“S-AIR”, then press or b.
3
Press V/v repeatedly to select
“RF SETUP”, then press or
b.
4
Press V/v repeatedly to select
the setting you want, then
press .
• RF AUTO: Normally select this. The
system changes “RF SETUP” to
“RF ON” or “RF OFF” automatically.
• RF ON: The system transmits sound by
searching the better channel for
transmitting.
• RF OFF: The system transmits sound by
fixing the channel for transmitting.
To exit the menu
Press AMP MENU.
Notes
• In most cases, you will not need to change this
setting.
• If “RF SETUP” is set to “RF OFF”, transmission
between the S-AIR main unit and S-AIR sub unit
can be performed using one of the following
channels.
– S-AIR ID A: equivalent channel for IEEE
802.11b/g channel 1
– S-AIR ID B: equivalent channel for IEEE
802.11b/g channel 6
– S-AIR ID C: equivalent channel for IEEE
802.11b/g channel 11
• The transmission may be improved by changing
the transmission channel (frequency) of the other
wireless system(s). For details, refer to the
operating instructions of the other wireless
system(s).
MENU
O
AMP
MENU
,
V/v/B/b