Sony STR-DH710 User Manual

Page 95

Advertising
background image

95

GB

Ad
ditional Inf

o

rmation

“HP NO LK” and “VOL MIN” appear
alternately in the display and the
volume of the receiver becomes
minimum.

• Volume becomes minimum when you turn

off the surround amplifier with
headphones connected or if the radio
reception is poor. In these cases, check the
radio reception and adjust the volume level
to restore sound from the headphone.

The remote does not function.

• Point the remote at the remote sensor on

the receiver.

• Remove any obstacles in the path between

the remote and the receiver.

• Replace all the batteries in the remote with

new ones, if they are weak.

• Make sure you select the correct input on

the remote.

The receiver is turned off
automatically.

• The “AUTO.STBY” function is working

(page 83).

If there is a malfunction, the display shows a
message. You can check the condition of the
system by the message. See the following table
to solve the problem. If any problem persists,
consult your nearest Sony dealer.
If an error message appears while you perform
Auto Calibration, see “When error codes
appear” (page 37) to
solve the problem.

PROTECTOR

Irregular current is output to the speakers, or
the upper panel of the receiver is covered
with something. The receiver will
automatically turn off after a few seconds.
Check the speaker connection and turn on
the power again.

Clearing the receiver’s memory may remedy
the problem (page 33). However, note that all
memorized settings will be reset to their initial
settings and you will have to readjust all
settings on the receiver.

Consult your nearest Sony dealer. Note that if
service personnel changes some parts during
repair, these parts may be retained.
In the event of a problem with S-AIR function,
have a Sony dealer check the entire system
together (S-AIR main unit and S-AIR sub
unit).

Remote commander

Others

Error messages

If you are unable to remedy the
problem using the
troubleshooting guide

If the problem persist

Reference sections for clearing
the receiver’s memory

To clear

See

All memorized settings

page 33

Customized sound fields

page 54

Advertising