Sanyo PDG-DWL2500 - Manual (Page 11)

11
i 3D SyNC OUT
Connect a 3D sync. signal cable for an IR wireless
emitter to this jack (p.48)
o LAN Connection Terminal
Connect the LAN cable (refer to the owner’s
manual of "Network Set-up and Operation").
!0 COMPUTER IN 1/COMPONENT IN
Connect output signal from a computer, RGB scart
21-pin video output or component video output to
this terminal (pp.16, 18).
!1 COMPUTER IN 2/MONITOR OUT
This terminal is switchable and can be used
for input from a computer or output to the other
monitor.
Set the terminal up as either Computer input or
Monitor output properly. [Used for Monitor out,
this terminal outputs only incoming signal from
COMPUTER IN 1/COMPONENT IN terminal (pp.
16, 56)].
!2 HDMI
Connect the HDMI signal from computer or video
equipment to this terminal (pp.16, 18).
q S-VIDEO IN
Connect the S-VIDEO output signal from video
equipment to this jack (p.17).
w VIDEO IN
Connect the composite video output signal to this
jack (p.17).
e AUDIO IN
Connect the audio output signal from video
equipment connected to q or w to this jack. For
a monaural audio signal (a single audio jack),
connect it to the L (MONO) jack (p.17).
r COMPUTER 1/COMPONENT AUDIO IN
Connect the audio output (stereo) from a computer
or video equipment connected to !0 or !2 to this
jack (pp.16, 18).
t COMPUTER 2 AUDIO IN
Connect the audio output (stereo) from a computer
connected to !1 to this jack (pp.16, 18).
y AUDIO OUT (VARIABLE)
Connect an external audio amplifier to this jack
(pp.16-18).
This terminal outputs sound from AUDIO IN
terminal (e, r or t) or HDMI terminal !2 (digital
audio).
u CONTROL PORT
When controlling the projector with RS-232C,
connect the control equipment to this connector
with the serial control cable.
Part Names and Functions
q
Side Terminal
w e r y t u i
o !0 !1 !2