Sanyo PDG-DWL2500 - Manual (Page 63)

63
Input Source Information Display
The Information Menu is used for checking the status of the image signal being projected and the operation of
the projector.
The information menu changes each time you press the
INFO. button on the remote control as follows.
page 1/2 a page 2/2 a hide a page 1/2 a • • • • •
While the information menu is displayed, press the Point 7
8 buttons to display the previous or next page. INFO . button
Remote Control
Press the Point ed buttons to select the Information. The
Information Menu is displayed.
See below for displayed information.
Information
Direct Operation
Menu Operation
Input The selected input source is displayed.
H-sync freq . The horizontal frequency of the input signal is displayed in KHz, or - - - -KHz when
no signal.
V-sync freq . The vertical frequency of the input signal is displayed in Hz, or - - - - Hz when no
signal. Numbers of Hz doubles when during Interlace.
Screen The selected screen size is displayed.
Language The selected language is displayed.
Lamp status The selected lamp mode is displayed.
Lamp counter The cumulative lamp operating time is displayed.
Power management Off, Ready, Shut down or Timer is displayed.
Key lock The selected Key lock icon is displayed.
PIN code lock Off or On 1 or On 2 is displayed.
Remote control The selected remote code is displayed.
SERIAL NO . The serial number of the projector is displayed. The serial number is used to service
the projector.
Information Menu