Samsung SPH-I325 - Manual (Page 156)

148 Safety
Acknowledging Special Precautions and Industry Canada Notice
Cautions
Any changes or modifications to your phone not expressly approved in this
document could void your warranty for this equipment, and void your authority to
operate this equipment. Only use approved batteries, antennas and chargers. The
use of any unauthorized accessories may be dangerous and void the phone
warranty if said accessories cause damage or a defect to the phone.
Although your phone is quite sturdy, it is a complex piece of equipment and can be
broken. Avoid dropping, hitting, bending or sitting on it.
Information to User
This equipment has been tested and found to comply with the limits of a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation; if this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
•
Reorient / relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Specific Absorption Rates (SAR) for Wireless Phones
The SAR is a value that corresponds to the relative amount of RF energy absorbed
in the head of a user of a wireless handset.
The SAR value of a phone is the result of an extensive testing, measuring and
calculation process. It does not represent how much RF the phone emits. All phone
models are tested at their highest value in strict laboratory settings. But when in
operation, the SAR of a phone can be substantially less than the level reported to
the FCC. This is because of a variety of factors including its proximity to a base
station antenna, phone design and other factors. What is important to remember is