Scientific Atlanta AllTouch 573480 - Manual (Page 12)

573497 Rev B 12
Getting your codes
After doing an All Search, find your 3-digit device codes. Follow the
steps below to find your codes.
1. Press and release the appropriate button for the device on the
AllTouch Remote Control. For example, if you are getting the
code for your VCR, press and release
VCR
.
Device Button
VCR
VCR
Auxiliary
AUX
TV
TV
HCT/Home Terminal
CBL
2. Press and hold
SET-UP
until the red light blinks twice.
3. Press
9 9 0
. The red light blinks twice.
4. Press and release the
1
,
2
, or
3
buttons on the remote
control to find each digit of the 3-digit code.
After pressing each button, count the number of times the red
light blinks. This number indicates the digit. There is a delay of a
few seconds before the blinks start. If the red light does not
blink, the digit is zero. Record your findings below.
Press this Record the Number of Blinks
Number Button VCR AUX TV
1
2
3
Enter the number
of blinks here
and on page 31.
1 2 3 1 2 3 1 2 3
5. Important! Remember to write the codes on page 31.
6. Repeat steps 1 through 5 for each device.