Scientific Atlanta AllTouch 573480 - Manual (Page 7)

573497 Rev B 7
Setting up the remote control to operate your VCR
To make the remote control work with your VCR, follow this procedure.
Important! If you are using a TV/VCR combination, you should set up
your VCR or TV/VCR combination code first, then go back to Setting
up the remote control to operate your TV. Use the same VCR code to
set up your TV, unless noted in code table on page 15.
1. Find the code for your brand of VCR in the back of this guide.
You may find more than one code for your particular brand. Start
with the first choice. Remember: If you are using a TV/VCR
combination, use a VCR code.
2. Press and release
VCR
, then hold down
SET-UP
until
the red light blinks twice.
Note: You may need to wait a few seconds for the
red light to blink twice.
3. Enter your 3-digit VCR code–the red light should
blink twice again. (If the red light does not blink
twice, return to step 1 and try again.)
4. Point your AllTouch Remote Control at your VCR
and press
POWER
.
5. Did your VCR turn off (or on)?
• If yes, you are finished setting up the remote
control for your VCR. Write your VCR code on
page 31.
• If no, go to step 6.
Notes:
• You may want to insert a tape and try
PLAY
,
FF
,
and
REW
to verify that all functions work. To record a
program, press
REC
twice.
• All VCR functions also work in TV and CBL modes.
6. If your VCR did not respond, repeat steps 2 through 5 trying all
of the codes (one at a time) under your brand.
7. If your VCR still did not respond, turn to All Search on page 10
and follow the steps.
VCR
1
4
7
2
5
8
0
3
6
9
AUX
V
O
L
S E L E
C T
REW
PAUSE REC STOP
PLAY FF
SET-UP BYPASS
MENU INFO
PPV
PREV. DAY NEXT DAY
M UT
E LA
ST
FAV
POWER
TV
CBL
C
H
T6055
SET-UP
VCR
GUIDE
B A C