Scientific Atlanta AllTouch 573480 - Manual (Page 14)

573497 Rev B 14
Volume Lock
After you program your TV code into your remote control, it will
automatically control the TV’s volume while operating in the TV, VCR,
or CBL modes. You can also program the remote control so that you
can control the volume through the HCT or TV/VCR combination
while operating in TV, VCR, or CBL modes. We call this Volume Lock.
Note: Volume Lock programming will remain active even if batteries
are removed for an extended period of time.
To switch your volume control to a device other than your TV, follow
the steps below.
1. Hold down
SET-UP
until the red light blinks twice.
2. Press
9 9 3
.
3. Press the appropriate device mode button (
CBL
or
VCR
). The red
light blinks twice. Your volume control is now locked to your
selected device mode.
Device Button Result
Home
CBL
Your remote control will now control the
Terminal volume through your home terminal.
TV/VCR
VCR
Your remote control will now control the
combination volume through your TV/VCR combination.
Important! If you have a TV/VCR combination
unit, you need to enter a TV code to control
volume. Once you enter the TV code, the
volume control will work in any mode. In
most cases the TV code is the same as the
VCR or TV/VCR combination code already
entered, but for the codes noted in the table
on page 15, a different TV code is required for
volume control.
Note: Your AllTouch Remote Control automatically controls only the
volume of your Aux device (CD Player) while in the AUX mode. You
cannot lock the volume to the AUX mode.