Scientific Atlanta AllTouch 573480 - Manual (Page 18)

573497 Rev B 18
Troubleshooting
Refer to the following table for solutions if you have trouble operating
your AllTouch Remote Control.
Problem Possible Cause Check and Correct
The red light • The battery Replace the batteries. Use
does not blink voltage is low. two AA alakaline batteries.
when you press • The batteries are Check that the batteries’
POWER
. inserted incorrectly. plus (+) and minus (–) symbols
match the illustration inside the
battery compartment.
The remote You may have the Press:
control does not remote control in •
VCR
for VCR
work properly or the wrong mode. •
AUX
for auxiliary device
home terminal/ •
TV
for TV
HCT functions •
CBL
for cable
do not work.
You may have used Follow these steps to program
an incorrect code to your remote control with the
program the remote correct code:
control.
1. Try all the codes listed
under the brand of your
device.
2. Try All Search and be sure
to go slowly. (See page 10.)
Important! Be sure to point
your AllTouch Remote Control
directly at your device when you
press
POWER
or
PLAY
.