Disabling/enabling channel control, Until the red light blinks twice. 2. press – Scientific Atlanta AllTouch 573480 User Manual
Page 16
573497 Rev B
16
Disabling/enabling channel control
This function enables or disables TV and VCR mode controls including
Channel Up/Down, Digits 0-9, Last Channel, and Favorite Channel.
With this programmable feature, the TV and VCR remains on the
correct output channel (either 3 or 4) so that the HCT operates
properly.
The channel control in TV and VCR mode is enabled as the factory
default.
To disable channel control in TV and VCR modes:
1. Press and hold
SET-UP
until the red light blinks twice.
2. Press
9
9
6
. The red light blinks twice.
3. Press CH ▼. The red light blinks twice.
To enable channel control in TV and VCR modes:
1. Press and hold
SET-UP
until the red light blinks twice.
2. Press
9
9
6
. The red light blinks twice.
3. Press CH ▲. The red light blinks twice.
Note: When TV and VCR channel control is disabled, the cable mode
channel control will be available in these modes.