Sub-Zero IC-27FI - Manual (Page 10)

Site Preparation 10
An anti-tip bracket and hardware is provided with the inte-
grated unit. Placement of the anti-tip bracket is critical to
a stable installation. The anti-tip bracket must be installed
on a solid base.
If you are installing the unit in a space deeper than 24"
(610) , be sure to locate the anti-tip bracket so that it
engages the unit properly. It is important that the anti-tip
bracket is placed 24" (610) from the front of the unit
(without panels) to the back of the anti-tip bracket.
IMPORTANT NOTE: In some installations the subflooring
or finished floor may require angling the wood screws
used to fasten the anti-tip bracket to the back wall.
WOOD FLOOR APPLICATIONS
Use the six #12 x 2 1 / 2 " wood screws and the six 1 / 4 " flat
washers provided. Drill pilot holes 3 / 16 " (5) diameter
maximum, and make sure the screws penetrate through
the flooring material and into the wall plate a minimum of
3 / 4 " (19) . Make sure the screws hold tight. Refer to the
illustration below.
CONCRETE FLOOR APPLICATIONS
Use the two 3 / 8 " x 3 3 / 4 " concrete wedge anchors, two
#12 x 2 1 / 2 " wood screws and two 1 / 4 " flat washers
provided. Make sure the anchors and screws hold tight.
Refer to the illustration below.
Anti-Tip Bracket Installation
Make sure there are no electrical wires or plumbing
in the area which the screws could penetrate.
To prevent the unit from tipping forward and provide
a stable installation, the unit must be secured in place
with the anti-tip bracket provided with the unit.
Anti-Tip Bracket Placement A
27" (686) Models 13 1 / 2 " (343)
36" (914) Models 18" (457)
A
A
SUBFLOORING
WOOD FLOOR
WALL PLATE
FINISHED
FLOORING
A
A
SUBFLOORING
CONCRETE
FLOOR
WALL PLATE
FINISHED
FLOORING
1 1 / 2 " (38)
min
Wood floor. Concrete floor.