Integrated installation, Molding installation, Water line connection – Sub-Zero IC-27FI User Manual

Page 13

Advertising
background image

Integrated Installation

13

subzero.com/specs

Molding Installation

Install the decorative white molding strips to the top and

sides of the integrated unit for a finished look. The top

molding strip, used on column and tall models, must be

installed before the side molding can be attached. The top

molding strip is held in place by double-sided velcro. The

side molding strips snap into place over brackets attached

to the side of the unit. Refer to the illustrations below for

positioning. For installations where units are side by side,

refer to dual installations on page 20.

If you choose, the molding strips may be painted to match

surrounding cabinetry. Follow these steps: Rough up the

surface to be painted with fine grit sandpaper. Wipe with

alcohol to ensure that the surface is clean and dry. Use an

appliance or industrial grade, oil base, high gloss enamel

paint.

TOP

MOLDING

Top molding.

Side molding.

SIDE

MOLDING

Water Line Connection

QUICK CONNECT WATER VALVE

For units with an ice maker, the quick connect water valve

and PEX tubing are located on the bottom right side of the

unit.

To connect the ice maker water line, attach the union

fitting to the house water supply line. Pull the coiled gray

PEX tubing with red cap and captured nut toward the

house water supply line. Remove and discard the red cap.

Then attach the tubing to the union with the nut. Tighten

all connections. Recoil the excess tubing under the unit.

Refer to the illustration below.

Turn on the water supply and check all fittings for leaks.

Make sure the electrical harness is attached to the

solenoid.

An in-line filter is required when water conditions have

a high sediment content.

The ice maker will not fill with water immediately. Allow 24

hours for proper ice production. The first container of ice

should be discarded. As with any new connection, there

may be impurities in the ice from the water supply line.

IMPORTANT NOTE:

Water lines must not be exposed to

freezing temperatures. Exposure could cause damage to

the unit and home.

PEX

TUBING

Water line connection.

Advertising