Sony SRP-X500P - Manual (Page 27)

SRP-X500P RS-232C Interface Manual
♦ INPUT LEVEL (16th-21st byte)
Shows the value indicated by the yellow triangular marker at the side of the input fader in the OVER
VIEW screen of the SRP-X500P Manager. This value is calculated using the input volume parameter,
input fader parameter, master volume level parameter, and remote fader 1-6 parameters and this
indicates the total input level value.
The INPUT LEVEL parameter consists of the 6 bytes of data in the order shown in the following table.
Byte Parameter
1st MIC 1/WL 1 INPUT LEVEL
2nd MIC 2/WL 2 INPUT LEVEL
3rd MIC 3 INPUT LEVEL
4th MIC 4 INPUT LEVEL
5th LINE INPUT LEVEL
6th AV/RGB INPUT LEVEL
The correspondence of the parameter with the level setting is the same as that of the FADER
parameter of the INPUT FADER command (page 7).
♦ OUTPUT LEVEL (22nd-29th byte)
Shows the value indicated by the yellow triangular marker at the side of the output fader in the OVER
VIEW screen of the SRP-X500P Manager. This value is calculated using the output fader parameter,
master volume level parameter, and remote fader 1-6 parameter. This value is an indication of the total
input level value.
The OUTPUT LEVEL parameter consists of 8 bytes of data in the order shown in the following table.
Byte Parameter
1st SPEAKER OUTPUT 1 LEVEL
2nd SPEAKER OUTPUT 2 LEVEL
3rd SPEAKER OUTPUT 3 LEVEL
4th SPEAKER OUTPUT 4 LEVEL
5th LINE OUTPUT 1 LEVEL
6th LINE OUTPUT 2 LEVEL
7th LINE OUTPUT 3 LEVEL
8th LINE OUTPUT 4 LEVEL
The correspondence of the parameter with the level setting is the same as that of the FADER
parameter of the INPUT FADER command (page 7).
♦ INPUT MUTING (30th byte)
Shows the muting status of the input channels in the form of 8 bits data.
The bit is 0 for a channel which is not turned off (
“ Muting off”) and 1 for a channel which is turned
off ( “ Muting on”).
MSB LSB
bit7 bit6 bit5 bit4 bit3 bit2 bit1 bit0
0 1 AV/RGB LINE MIC 4 MIC 3 MIC 2 MIC 1
/WL 2 /WL 1
Page 27/43