Sharp AR-C260 - Manual (Page 127)

TROUBLESHOOTING
7-5
7
Order of copies
incorrect Is the order of originals correct? When using the document glass, set the
originals from the first page one sheet at a
time.
When using the reversing automatic
document feeder, set the originals with the
first page up.
Color copies are being made on special
paper such as heavy paper 2, transparency
film, or envelopes (paper that can only be
output face up). When special paper such as heavy paper 2,
transparency film, or envelopes (paper that
cannot be output to the center tray) is used,
copies are output face up to the left tray.
When making color copies on paper that can
only be output face up, the copies are output
face up in the order of scanning, and thus
the stack of copies is in the reverse order of
the stack of originals. When making black
and white copies on paper that can only be
output face up, the copies are output face up
in the reverse order of scanning, and thus
the stack of copies is in the same order as
the stack of originals.
Job cancelation
needed Is a message requesting cancelation of job
displayed? Press the [CA] (clear all) key to cancel the
current job.
Scanning of
originals is
incomplete. Is a message indicating memory is full
displayed? If the data amount exceeds the limit when
using the pamphlet copy or multi shot copy
which requires scanning of all originals,
scanning will be canceled and copying will
not be performed.
If you install an additional memory, the
storage capacity will increase.
The selected
number of sets of
copies is not printed. Has "Sort" been selected and is color
copying being performed? When color copying is performed and "Sort"
is selected, only one set of copies can be
made. If more than one set is needed,
replace the original and repeat the copy
procedure for each set needed.
Not all pages are
copied When making black and white copies, the
memory became full during scanning of the
originals and a message appears asking
you whether you want to continue copying or
cancel. When the memory becomes full during
scanning of the originals, you can select
whether you want to continue the job and
print only those originals that were scanned,
or cancel the job. If you continue the job,
copies will only be made of the originals that
were scanned, and thus all originals cannot
be copied at once.
Problem Check Solution or cause
00-08.book 5 ページ ２００２年１１月８日 金曜日 午前９時３９分