Sharp AR-C260 - Manual (Page 55)

SADDLE STITCH FINISHER
3-7
3
Staple cartridge replacement and staple jam removal
When the staple cartridge becomes empty or staples become jammed, a message will appear in the message
display of the operation panel.
Follow the procedure below to replace the staple cartridge or remove jammed staples.
■ ■ ■ ■ Staple cartridge replacement
1 Open the front cover.
2 Pull out the stapler section.
3 Remove the empty staple box.
4 Remove the empty staple cartridge.
Press the lock button to
unlock the staple box
cover and remove the
staple cartridge.
5 Insert a new staple cartridge into the
staple box.
After inserting the staple
cartridge, press down on
the staple box cover to
lock the cartridge in
place.
6 Remove the tape from the staple cartridge
by pulling it straight.
7 Insert the staple box.
Push the staple box in
until it clicks into place.
8 Push the stapler section back into the
finisher.
9 Close the front cover.
NOTE
If staples remain,the staple cartridge cannot be
removed.
NOTES
● Do not remove the tape from the cartridge before
inserting the staple cartridge into the box.
● When reinstalling the staple box, push it in until it
clicks into place.
NOTE
Make a test print or copy in the staple sort mode to
ensure that stapling is performed properly.
00-08.book 7 ページ ２００２年１１月８日 金曜日 午前９時３９分