Sharp AR-C260 - Manual (Page 58)

SADDLE STITCH FINISHER
3-10
Misfeed in the saddle stitch finisher
When a misfeed occurs in the saddle stitch finisher, remove the misfed paper following the procedure below.
1 Unlatch the saddle stitch finisher and slide
it away from the main unit.
2 Remove the misfed paper from the main
unit.
After removing the
misfed paper, open and
close the duplex bypass/
inverter to reset the jam
indicator. ("Misfeed in
the Fusing area" step 1
or 4 on page 2-20)
3 If misfed paper is not found in step 1, open
the top cover.
4 While pulling and turning roller rotating
knob B, remove the misfed paper. (when
the punch unit is installed)
When the misfed paper
is removed by turning
roller rotating knob B,
remove it taking care not
to tear the paper.
Roller rotating knob B
5 Close the top cover.
6 If saddle stitching was selected, open the
front cover.
7 Turn roller rotating knob C as shown in the
illustration until the blue indication is
seen.
8 Remove the misfed paper from the stapler
compiler.
Be careful not to tear the
misfed paper during
removal.
9 Open the saddle stitch section cover.
Blue
Roller rotating
knob C
00-08.book 10 ページ ２００２年１１月８日 金曜日 午前９時３９分