Reversing automatic document feeder, Acceptable originals, Size and weight of acceptable originals – Sharp AR-C260 User Manual
Page 73: Reversing automatic document feeder -5, Acceptable originals -5, 4reversing automatic document feeder
4-5
4
REVERSING AUTOMATIC DOCUMENT FEEDER
Originals set in the optional reversing automatic document feeder will be automatically fed and copied sequentially.
The optional reversing automatic document feeder will handle 5-1/2" x 8-1/2" to 11" x 17" originals.
Two-sided originals can be copied automatically without having to manually turn them over.
Acceptable originals
A stack of up to 100 original sheets (8-1/2" x 11" (A4) size, 20lbs. (80g/m
2
)) of the same size paper can be set in the
document feeder tray. Originals of mixed size can be set if the width of the originals is the same.
■
■
■
■ Size and weight of acceptable originals
■
■
■
■ Total number of originals that can
be set in the document feeder tray
● 100 pages (8-1/2" x 11" (A4) size originals
weighing 20 lbs. (80 g/m
2
)) (For originals heavier
than 20 lbs. (80 g/m
2
), the maximum stack
thickness is 13/32" (10 mm).)
● 60 pages (8-1/2" x 14" (B4) size or larger
originals weighing 20 lbs. (80 g/m
2
))
(For originals heavier than 20 lbs. (80 g/m
2
), the
maximum stack thickness is 64" (6 mm).)
Notes on use of the reversing automatic document feeder
●Use originals within the specified size and weight ranges. Use of originals out of the specified range may cause
an original misfeed.
●Before loading originals into the document feeder tray, be sure to remove any staples or paper clips.
●If originals have damp spots from correction fluid, ink or glue from pasteups, be sure they are dried before they
are fed. If not, the interior of the document feeder or the document glass may be soiled.
●To prevent incorrect original size detection, original misfeeds or smudges on copies, use the following as a
guide for feeding originals.
Transparency film, tracing paper, carbon paper, thermal paper or originals printed with thermal transfer ink
ribbon should not be fed through the document feeder. Originals to be fed through the feeder should not be
damaged, crumpled or folded or have loosely pasted paper on them or cutouts in them. Originals with
multiple punched holes other than two-hole or three-hole punched paper may not feed correctly.
●When using originals with two or three holes, place them so that the
punched edge is at a position other than the feed slot.
14 lbs. or
50g/m
2
2
2
54 lbs. or
200g/m
2
Original size:
(148 x 210 mm)
5-1/2" x 8-1/2"
or A5
11" x 17"
or A3
(297 x 420 mm)
Weight (thickness):
one-sided original:
14 lbs. or
50g/m
2
42 lbs. or
156 g/m
2
two-sided original:
g/m
... Weight of a sheet of paper of 1 m
Hole positions
Hole positions
Hole
positions
00-08.book 5 ページ ２００２年１１月８日 金曜日 午前９時３９分