Sony CDP-D11 - Manual (Page 5)

Preparations
5
3
Connect the AC power cord to the wall
outlet.
•
Audio connecting cord XLR type
•
Coaxial digital connecting cable VMC-10, etc.
•
Optical digital connecting cable POC-15A, etc.
•
Control S cord (supplied)
•
Relay playback cord (RK-G136, etc.)
1
Prepare the necessary connecting
cord.
•
Audio connecting cord (pin type)
2
Connect the cord.
p To connect to an analog equipment
Use the terminals and switch as below.
p To connect to a digital equipment
(MD recorder, DAT recorder, mixer with
digital input terminal, etc.)
Digital recording can be carried out by
connecting to MD or DAT recorder. Use
coaxial digital connecting cable VMC-10
(optional) or optical digital connecting cable
POC-15A (optional), etc.
•
When using coaxial digital cable
•
When using optical digital connecting cable
z To use the supplied remote control as the
wired remote control
Connect the terminal on the front side of the remote
control and the CONTROL terminal of the main unit
with the CONTROL S cord (supplied).
When the remote control and the main unit is
connected with the CONTROL S cord, the infrared ray
is not set out from the remote control and is not
received at the main unit.
To use as the wireless remote control, disconnect the
plugs from both the main unit and the remote control.
CD player Digital equipment
: Flow of the signals
Analog output terminal
UNBAL (pin type)
(Mini jack) (Mini jack)
(Stereo mini jack) (Stereo mini jack)
Analog output terminal
BAL (XLR type)
OUTPUT LEVEL
switch
z When BALANCE output (XLR type)
terminal is used, output level can be changed
by OUTPUT LEVEL switch.
Position
+4dBu
-10dBu
Output level
The signal of -20dB in digital is
output in +4dBu level.
The signal of -20dB in digital is
output in -10dBu level.
Specification of the BALANCE output
connector.
Equivalent to XLR-3-32
output terminal
1: GND
2: HOT
3: COLD
CD player Digital equipment
DIGITAL OUT
DIGITAL OUT
: Flow of the signals
Red Red
Left (L)
Right (R)
White White
Left (L)
Right (R)