Sony HIPATH 8000 - Manual (Page 4)

Safety precautions
4
Trademarks
Customer Information
FCC and Industry Canada Compliance
This section describes the requirements for compliance with Federal Com-
munications Commission (FCC) Rules and Industry Canada CS-03 stan-
dard.
FCC Compliance and Requirements
The following customer information is based on FCC rules and ACTA re-
quirements.
Service
If you experience problem with the Siemens “OpenStage” IP-based tele-
phones, contact Siemens customer support at 1-800-TEL-ROLM for infor-
mation on service and repairs. The telephone company can ask you to dis-
connect the equipment from the network until the problem is corrected or
until you are sure that the equipment is not malfunctioning.
FCC Rules, Part 15
The Siemens “OpenStage” IP-based telephone has been tested and found
to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection
The device conforms to the EU directive 1999/5/EC as at-
tested by the CE marking.
All electrical and electronic products should be disposed of
separately from the municipal waste stream via designated
collection facilities appointed by the government or the local
authorities.
Proper disposal and separate collection of your old appli-
ance will help prevent potential damage to the environment
and human health. It is a prerequisite for reuse and recycling
of used electrical and electronic equipment.
For more detailed information about disposal of your old ap-
pliance, please contact your city office, waste disposal ser-
vice, the shop where you purchased the product or your
sales representative. The statements quoted above are only
fully valid for equipment which is installed and sold in the
countries of the European Union and is covered by the direc-
tive 2002/96/EC. Countries outside the European Union
may impose other regulations regarding the disposal of
electrical and electronic equipment.