Sharp VL-WD250U - Manual (Page 21)

8
Preparation
Attaching and Removing the
Battery Pack
Attaching the Battery Pack
1
Make sure that the Power switch is set
to OFF.
Power switch
2
Lift up the viewfinder.
Power source
mounting surface
3
Align the - mark on the side of the
battery pack with the q mark on the
camcorder ( 1 ), and slide the battery
pack down completely until it locks into
place (
2 ).
4
Lower the viewfinder.
Removing the Battery Pack
1
Perform steps 1 and 2 above.
Power source PUSH
release button
2
Press the power source PUSH release
button (
1 ), and slide the battery pack
up and take it out ( 2 ).
Cautions:
• BEFORE REMOVING THE BATTERY PACK,
ALWAYS STOP RECORDING OR PLAYBACK
AND TURN THE POWER OFF.
If you remove the
battery pack during recording or playback, the
tape will remain wound around the video head
drum, potentially causing damage to the tape.
• Remove the battery pack from the camcorder if
you will not use the camcorder for a long period
of time.
• Use only SHARP model BT-L221 or BT-L441
battery packs with this camcorder. Use of other
batteries may present a risk of fire or explosion.