Sun Microsystems TIMBERWOLF 9740 - Manual (Page 27)

95693 Revision P 2-1
2
Controls and Indicators
This chapter shows and describes the power switch and operator panel for the
LSM. It also describes how to set the SCSI address as well as the maximum
usage count of the cleaning cartridges. Refer to the controller transport unit or
tape drive operator guides for information about operating those units.
■
Power Switch
The LSM power switch is a circuit breaker located in the lower right corner of the right
front door of the LSM. The switch provides power to the LSM only.
Figure 2-1 shows
the LSM power switch location.
Figure 2-1. LSM Power Switch (C62018)
C62018
DETAIL A
POWER
SWITCH
A