Mounting a cartridge into a t9840 drive, Mounting a cartridge into a t9840 drive -24 – Sun Microsystems TIMBERWOLF 9740 User Manual

Page 56

Advertising
background image

Operating in Manual Mode

3-24

Revision P

95693

Mounting a Cartridge into a T9840 Drive

Important: T9840A/B and T9840C VolSafe cartridges are not interchangeable. T9840C
tape drives can read the 20-GB VolSafe tape cartridges used in T9840A and T9840B
drives, but cannot write to them. The 40-GB VolSafe tape cartridges used in T9840C
drives cause a load error when mounted in a T9840A or T9840B drive.

See

“T9840 and T9940 Tape Drives” on page 4-5

for more information.

To load the cartridge in a T9840 drive:

1. Follow the steps in

“Mounting and Dismounting Cartridge Tapes” on page 3-19

.

2. Insert the cartridge into the drive using the direction shown in

Figure 3-13

.

3. Wait for one of the following messages to display and take the appropriate

action, if necessary:

•

The Ready A message displays when the drive is VolSafe-enabled and
loaded with a write-enabled VolSafe cartridge.

•

The Ready F (File Protected) message displays when a write-protected
cartridge loads successfully.

•

The Ready U (File Unprotected) message displays when a cartridge
that is not write-protected loads successfully.

•

The NTReady message displays when the tape in the cartridge has lost
tension. Follow the instructions outlined in the T9840 Tape Drive User’s Reference
Manual
to correct this condition.

•

The LOADxxxx message displays when the cartridge unsuccessfully
loads, where the xxxx is a fault symptom code.

Advertising