Sun Microsystems TIMBERWOLF 9740 - Manual (Page 85)

95693 Revision P A-15
Setting the Write-Protect Switch
DLT Write-Protect Switch
To write-enable a DLT cartridge:
1. Hold the cartridge with the rear VOLSER label toward you.
2. Locate the write-protect switch on the front of the cartridge.
3. Slide the write-protect switch to the right so that the orange indicator is not visible.
To write-protect this cartridge, slide the switch to the left so that the orange indicator
is visible.
Figure A-17. Setting the DLT Write-Protect Switch (C62382)
C62382
WRITE-PROTECTED POSITION
ORANGE
INDICATOR
WRITE-ENABLED
POSITION