Speco Technologies 10X PAN-TILT HTSD10X - Manual (Page 23)

23
I. ALARM SET
4 Alarm inputs are available and each alarm can activate presets, group tours or patterns.
I-1. ALARM SET – ALARM NO.
Up to 4 alarms are selectable by using the joystick to the right when the cursor is on ALARM NO.
I-2. ALARM SET – ALARM INPUT
Input alarm provides two different ways - NC (Normal Close) or NO (Normal Close)
I-3. ALARM SET – ALARM ACT
Alarm activates various surveillance modes with Preset number up to 164, Group tour up
to 8, Pattern up to 8. Move the joystick to the right or left direction to select any preset
number, group tour no. or pattern no.
I-4. ALARM SET – SAVE
After setting the alarm input parameters, to save the data, move the joystick to the right when the
cursor is on SAVE. After saving the data, the cursor moves to Alarm NO.2 automatically to prepare
the next alarm.
I-5. ALARM SET –EXIT
To escape this page, move the joystick to the right
* Before activating an Alarm, user must set ALARM ENABLE at DOME SET – ALARM – ENABLE
(Refer to page 15)
OSD MENU SETTING
ALARM SET
ALARM NO : 01
ALARM INPUT: OFF
ALARM ACT : 001
SAVE
EXIT
DEFAULT SETTING