Speco Technologies 10X PAN-TILT HTSD10X - Manual (Page 9)

9
When the Power is turned on a DIAGONOSTIC is operated.
The following messages are displayed on the monitor.
A.
Pan Origin Test
Zero point of Pan is founded after Panning test.
B. Tilt Origin Test
Zero point of Tilt is founded after Tilting test.
C .
TX connection Test
Countdown from 60 seconds for TX Connection Test,
During the 60 seconds the camera must receive a signal from any keys of controller or DVR.
When received the correct signal, OK is displayed after TX CONNECTION TEST.
* If “Not Tested” is displayed on the monitor,
- Camera did not receive the any signal.
- Camera did receive the signal but it was not correct.
- User should check protocol, baud rate and RS-485 connection.
D.
Camera Comm. Test
Communication test with the camera is automatically checked.
OK should be displayed in these four tests before installation.
DIAGNOSTIC
CAMERA ID : 001
BAUD RATE : 2400 BPS
WAITING………
PAN ORIGIN CHECK OK
TILT ORIGIN CHECK OK
TX CONNECTION TEST OK
CAMERA COMM TEST OK
QUICK OPERATING KEYS