Sony HDW-M2000 - Manual (Page 104)

Chapter 9
Setup Menus
9-8
Chapter 9 Setup Menus
Item number Item name Settings
009 a) CHARACTER TYPE
011 a) CHARACTER V-SIZE
SYSTEM FREQUENCY
SELECT
9-3 Items in the Basic Setup Menu
Determines the type of characters such as time code output from the
COMPOSITE VIDEO OUTPUT 3 (SUPER) connector, HDSDI OUTPUT 3
(SUPER) connector, and SDI OUTPUT 3 (SUPER) connector for superimposed
display on the monitor.
WHITE : White letters on a black background
BLACK: Black letters on a white background
W/OUT: White letters with black outline
B/OUT: Black letters with white outline
Determines the vertical size of characters such as time code output from the
COMPOSITE VIDEO OUTPUT 3 (SUPER) connector, HDSDI OUTPUT 3
(SUPER) connector, and SDI OUTPUT 3 (SUPER) connector for superimposed
display on the monitor.
×1 : Standard size
×2: 2 times standard size
Specify whether to enable switching of the system frequency between 59.94 Hz
and 50 Hz.
OFF : Disable switching.
ON: Enable switching.
When ON is selected, the menu display changes to allow switching of the setting
between 59.94 Hz and 50 Hz.
Switching the system frequency enables the unit to operate at the system
frequency switched to.
For the procedure for switching the system frequency, see page 9-4.
Notes
• For the basic and extended setup menus, separate settings are saved for 59.94
and 50 Hz modes. When you switch systems, all menu items change to the
settings established in the new system. (These are different from the settings for
the mode before switching.)
• When the unit is used in 50 Hz mode, analog tape can only be played back in
the simple playback mode.
013
a)When setting items 009 and 011, watch the monitor
screen, and adjust to the required state.
018 ACTIVE LINE SELECT
(Valid only in 59.94 Hz
mode) Enable or disable switching of the number of active scan lines for HDSDI output
(OFF TAPE/1035/1080).
OFF : Disable switching.
ON : Enable switching.
When ON is selected, the menu display changes to allow switching of the setting
between OFF TAPE, 1035, and 1080.
For the procedure for switching the number of active scan lines, see page 9-4.
Note
To enable setup menu item 918 SLOW PROCESS MODE, this item must be set
to OFF TAPE.
(Continued)