Sony HDW-M2000 - Manual (Page 93)

Chapter 8
Function Menu
Chapter 8 Function Menu
8-5
Page 2
Item Setting
F1 (V.PROC) Selects the control method for the internal digital video processor.
LOCAL: Change the settings of the internal digital video processor by using this function menu.
REMOTE: Use the optional BVR-50/50P Remote Control Unit to control the internal digital video
processor.
MENU: Change the settings of the internal digital video processor by using F5 (MENU) of the HOME page.
Notes
When controlling the unit from the HKDV-503/900, set this item to MENU.
F2 (VIDEO) Sets the HD/SD video signal output level (– ∞ to +3 dB).
PRESET: Regardless of manually set values, the video signal is set to the standard level.
Manual setting: With the displayed setting flashing, you can rotate the MULTI CONTROL knob to adjust
the value for the video signal output level.
F3 (CHROMA) Sets the HD/SD chroma signal output level (– ∞ to +3 dB).
PRESET: Regardless of manually set values, the chroma signal is set to the standard level.
Manual setting: With the displayed setting flashing, you can rotate the MULTI CONTROL knob to adjust
the value for the chroma signal output level.
F4 (HUE)
(59.94 Hz mode)/
(C PHAS)
(50 Hz mode) Sets the color phase (phase relative to burst)
PRESET: Regardless of manually set values, sets the color phase to the standard value.
Manual setting: With the displayed setting flashing, you can rotate the MULTI CONTROL knob to adjust
the value across the range ±30°.
F5 (SETUP)
(59.94 Hz mode)/
(BLACK) (50 Hz
mode) Sets the setup level (59.94 Hz mode) or black level (50 Hz mode)
PRESET: Regardless of manually set values, the level is set to the standard value.
Manual setting: With the displayed setting flashing, you can rotate the MULTI CONTROL knob to adjust
the setup level across the range ±30 IRE (59.94 Hz mode) or to adjust the black level across the range
±210 mV (50 Hz mode).
F6 (YC DLY) Sets amount of Y/C delay for playback of analog Betacam tapes.
PRESET : Regardless of manually set values, the Y/C delay is set to the standard value.
Manual setting: With the displayed setting flashing, you can rotate the MULTI CONTROL knob to adjust
the Y/C delay across the range ±100 ns.