Sony HDW-M2000 - Manual (Page 32)

Chapter 3
Preparations
3-2
Chapter 3 Preparations
3-2 Reference Sync Signals
This section describes how reference signals for the
video output signals and servo system are selected.
The output from the internal reference video signal generator is supplied to the output video signal and
servo circuits as a reference signal.
3-2-1 Selecting Reference Signal Depending on Operational Status
The reference signal selction switches automatically
between REF and INPUT depending on the men
F2 (OUTREF) setting Menu item 309 setting Menu item 334 setting Unit’s operational
status a)
Reference signal
setting
— EXT — EE REF
PB
EDIT
REC
INPUT EE INPUT
PB REF
EDIT
REC
REF AUTO1 NORMAL EE
PB
EDIT
REC INPUT
INPUT EE
PB REF
EDIT
REC INPUT
INPUT — EE
PB
EDIT
REC
REF AUTO2 NORMAL EE REF
PB
EDIT INPUT
REC
INPUT EE
PB REF
EDIT INPUT
REC
INPUT — EE
PB
EDIT
REC
a) EE: In E-E mode
PB: Playing back (normal playback, job mode, shuttle mode, variable-speed mode, and also stop mode)
EDIT: Edit preset enabled
REC: Recording
settings and the operating status of the unit, as shown
in the following table.