Sherwood R-925 - Manual (Page 17)

17
Press the MEMORY/ENTER button.
4
Enter a preset number (1~30).
5
Press the desired preset number.
2
Presetting radio stations
Tuning to preset stations
You can store up to 30 preferred stations in the
memory.
“MEMORY” is flickering for 5 seconds.
Examples)
For “3” :
For “15” :
The station has now been stored in the memory
A stored frequency is erased from the memory by
storing another frequency in its place.
If “MEMORY” goes off, press the MEMORY/ENTER
button again to enter a preset number.
Example)
For “3” :
For “15” :
When pressing the numeric buttons on the front
panel without selecting the TUNER, the tuner will be
selected automatically and the preset station will be
tuned in.
Listening to FM stereo broadcasts
While listening to FM broadcasts.
Each time this button is pressed, the FM mode
changes as follows;
Stereo mode : “ST” lights up
Mono mode : “ST” goes off
When FM stereo broadcasts are poor because of weak
broadcast signals, select the FM mono mode to reduce
the noise, then FM broadcasts are reproduced in
monaural sound
The receiver will start scanning the stations in the
preset sequence and each station is received for 5
seconds.
Scanning preset stations in sequence
1
At the desired station, press this button
again to stop scanning.
2
Tune in the desired station with auto or
manual tuning, etc.
3
ENGLISH
MEMO / ENTER
or
3
3
or
5 1
1 5
within 2 seconds
within 2 seconds
or
3
3
or
5 1
1 5
within 2 seconds
within 2 seconds
SCAN P.
FM MODE
MEMORY BACKUP FUNCTION
The following items, set before the receiver is turned off,
are memorized.
If the electricity fails or the AC input cord is
disconnected for about 2 weeks, they are all cleared.
So you should memorize them again.
• INPUT SELECTOR settings
• VCR 1 RECORD settings
• Surround mode settings
• Preset stations
• Video labels, etc.