Sherwood R-925 - Manual (Page 5)

5
MULTI
ROOM
VIDEO
MON. DIGI-LINK
+
+
-
-
+
+ +
-
- -
L R
L R
CENTER SPEAKER(8 Ω)
REAR SPEAKERS(8 Ω)
FRONT SPEAKERS(8 Ω)
AC INPUT ~120V / 60Hz
GND
+
+
-
-
+
+ +
-
- -
ANTENNA
L
L
REAR PRE OUT
MULTI ROOM
CENTER
PRE OUT
AM LOOP
MAIN IN DIGITAL INPUTS AC-3 RF L R
L
L R
L R
R
L R
PHONO VIDEO
DVD
VCR 1 PLAY
LDP
TV/AUX
DIGI-LINK CENTER SPEAKER(8 Ω)
REAR SPEAKERS (8 Ω)
FRONT SPEAKERS(8 Ω)
FM
75 Ω
AC OUTLETS
AUDIO/VIDEO RECEIVER
MODEL NO. R-925
SWICTHED ~120V / 60Hz TOTAL100W 1A MAX
VIDEO MON.
VCR 1 REC
CD
TAPE 1 PLAY
TAPE 2 PLAY
TAPE 1 REC
TAPE 2 REC
COAXIAL
OPTICAL
SUB WOOFER
R
R
■ CONNECTING MULTI- ROOM ADAPTOR
CONNECTING SYSTEM CONTROL
■ CONNECTING SPEAKERS
OUT
Connect this jack to the output of the multi-room adaptor.
For information on the multi-room adaptor, contact the Xantech
corporation at 1-800-843-5465.
Adaptor
• A digital input should be connected to the components such
as LD player or DVD, etc. capable of outputing Dolby AC-3,
PCM or RF format digital signals.
• For details, refer to the operating instructions of the
component connected.
• Connect this jack to the DIGI LINK jack of the external
Sherwood component that uses the DIGI LINK II or III remote
control system.
• Never short circuit the + and – speaker cords.
• Be sure to connect speakers firmly and correctly
according to the channel (left and right) and the polarity
(+ and –).
• Be sure to use the speakers with the impedance of over
8 Ω.
• Always connect both rear speakers.
• For installing the speakers, refer to "Speaker placement"
on page 13.
CD player
Sherwood component
with DIGI LINK II or III
Tape deck
Graphic equalizer
Front right Front left
Rear right
Center
Rear left
System
control
cord
DIGITAL
INPUTS
COAXIAL
OPTICAL
AC-3/PCM
AC-3 RF
PRE OUT
AC-3/PCM
SER. NO
LD player with
DIGITAL RF OUT
Component with
COAXIAL DIGITAL OUT
Component with
OPTICAL DIGITAL OUT
■ CONNECTING DIGITAL INPUTS
ENGLISH