Sony J30SDI User Manual

Page 20

Advertising
background image

Chapter 2

Location and Function of Parts

Chapter 2

Location and Function of Parts

2-9

DV (i.LINK DV) output connector (IEEE1394,

6-pin):

Outputs video/audio signals in DV format
(IEEE1394, 6-pin).
When basic menu item 030, i.LINK
CHARACTER, of the setup menu is set to ON
and basic menu item 005, DISPLAY
INFORMATION SELECT is set as anything other
than OFF, the output from this connector outputs
superimposed character information such as time
code, menu settings, or alarm messages.

Notes

• Through the DV connector, only one DV

device can be connected to this unit. If you
intend to connect multiple DV devices, refer to
the manuals of them.

• The i.LINK (DV) output of this unit is used to

provide materials to a computer on which non-
linear editing software is installed. You can use
a Sony VTR equiped with an i.LINK (DV)
connector (DVCAM series of VTRs for
example) with this unit, though, the auto
dubbing function and editing function will not
be available.

• If the unit is connected to a device equipped

with a 6-pin DV jack, when you intend to
disconnect or reconnect the DV cable, turn off
the device and pull out the plug of its power
cord from the AC outlet beforehand. If you
connect or disconnect the DV cable while the
device is connected to the AC outlet, high-
voltage current (8 to 40 V) is output from the
DV jack of the device to this unit, which may
cause a malfunction.

• When connecting a device that has a 6-pin DV

jack to this unit, first connect the plug of the
cable to the 6-pin DV jack of the device.

COMPONENT (Y/R–Y/B–Y) output connectors
(BNC):
Output analog component video signals (Y/

R–Y/B–Y).

6

AUDIO MONITOR OUTPUT connectors

Audio monitor (L/R) output connectors (XLR
3-pin, male):
Output two (L and R) audio monitor

signals according to the setting of the AU MON
SEL/BOLBY C NR button on the control panel.

Audio monitor (L/R) output connectors (Phono
jack):
Output two (L and R) audio monitor signals

according to the setting of the AU MON SEL/
DOLBY C NR button on the control panel.

Advertising