Sony J30SDI - Manual (Page 48)

7-4 Extended Menu
Chapter 7
Setup Menu
7-12
Chapter 7 Setup Menu
808 INTERNAL AUDIO
SIGNAL GENERATOR Select the operation of the internal audio test signal generator.
OFF : No operation.
1KHZ: At 1 kHz, –20 dB FS sine wave is output on all audio output channels.
831 a) i.LINK AUDIO OUTPUT
SELECT Selects audio channels output from the DV connector.
CH1/2 : Outputs audio signals (16 bits/48K) recorded in CH-1/2.
CH3/4: Outputs audio signals (16 bits/48K) recorded in CH-3/4.
CH1/2/3/4: Outputs audio signals (12 bits/32K) recorded in CH-1/2/3/4.
CH5/6: Outputs audio signals (16 bits/48K) in CH-5/6 (J-30/30SDI).
CH7/8: Outputs audio signals (16 bits/48K) in CH-7/8 (J-30/30SDI).
CH5/6/7/8: Outputs audio signals (12 bits/32K) in CH-5/6/7/8 (J-30/30SDI).
901 b) VIDEO OUTPUT DATA
(J-10SDI/30SDI only) Set the bit length of the signal output from the SDI output connector.
10bit : When connecting to a 10-bit system
8bit: When connecting to a 8-bit system
Item number Item name Settings
a) Audio signals are muted if you select the channel
unavailable for the format you are using.
b) Select the bit length used in the system to which this unit
is connected.
922 IMX NOISELESS PB
SELECT
(J-30/30SDI only) Select the noiseless playback picture output when using the MPEG IMX format.
FRAME : Frame picture
FIELD1: Field 1 picture
FIELD2: Field 2 picture
802 DIGITAL AUDIO MUTE IN
SHUTTLE MODE Set the digital audio muting conditions during shuttle playback.
OFF : Not muted.
CUEUP: Muted during cue-up or preroll operations.
FULL: Muted in shuttle mode.
SLOW: Muted in ±0.2 times or slower.
719 SYSTEM PHASE SYNC Adjust the SYNC phase of the output signal.
Default value: 3FH
721 Y/C DELAY Adjust the Y/C delay for playback from an analog Betacam cassette.
Default value: 800H