Woodstock SHOP FOX W1712 - Manual (Page 28)

ADJUSTMENTS
-16-
The disc table clearance has been correctly set
at the factory, but over the life of your
machine adjustments may need to be made.
To adjust the disc table clearance, do these
steps:
1. UNPLUG THE SANDER!
2. Make sure the disc table is set to 0˚.
3. Loosen the four table adjustment bolts
(
Figure 14).
4. Measure the gap between the table edge
and the face of the disc at the left and
right end locations.
5. Adjust the clearance at each location to be
approximately
1 ⁄
8
".
6. Tighten the adjustment bolts when the
proper clearance has been achieved
.
Figure 14. Disc table adjustment bolts
(only 2 of 4 shown).
Disc Table Alignment
Adjustment
Bolts