Woodstock SHOP FOX W1712 - Manual (Page 33)

OPERATIONS
-21-
To change the sanding belt, do these steps:
1. UNPLUG THE SANDER!
2. Remove all the cover lock knobs from the
back of the belt guard and slide the belt
guard up and off the sanding belt as shown
in
Figure 23.
3. Remove the table and mounting bracket
from the belt sander (
Figure 24).
4. Release the belt tension by moving the
belt tension lever to the “unlock” position.
5. Roll the old sanding belt off the right side
of the rollers.
6. Install a new belt with the arrows in the
proper direction as shown in
Figure 25.
7. Re-install the mounting bracket, table and
belt guards.
Figure 23. Removing belt guard.
Figure 25. Installing a new sanding belt.
UNPLUG the power cord
when making any adjust-
ments during operation!
Otherwise, serious per-
sonal injury to you or
others may occur!
Changing Sanding
Belt
Figure 24. Table and mounting bracket.
Table and Mounting
bracket