Sharp R-21AT - Manual (Page 34)

32
A30317, SUK R-21AT O/M
ROUBLESHOOTING
T
If you think the oven is not working properly there are some
simple checks which you can carry out yourself before you
call for an engineer. This will help prevent unnecessary
service calls if the fault is something simple.
Simply answer "YES" or "NO" to the following questions:
1 Does the oven lamp come on when you open the
door? YES/NO
Put half a cup of water on the ceramic floor in the oven
and close the door. Cook for 1 minute at 100%.
2 Does the oven lamp come on? YES/NO
3 Does the fan motor work? (Check by placing your
hand above the air vent openings) YES/NO
4 After 1 minute does the "Beep" signal sound?
YES/NO
5 And did the heating indicator "ON" go out?
YES/NO
6 Is the water in the cup hot? YES/NO
If you answer "NO" to any question first check that the
oven is plugged in properly and the fuse has not blown, if
there is no fault with either, check against the trouble-
shooting chart below.
• Never adjust, repair or modify the oven yourself,
or allow anyone other than a Service Technician,
appointed by SHARP to carry out the service.
• The door seal stops microwave leakage during oven
operation, but does not form an airtight seal. It is nor-
mal to see drops of water, light or feel warm air around
the oven door. Food with a high moisture content will
release steam and cause condensation inside the door
which may drip from the oven.
• Repairs & Modifications: Do not attempt to operate the
oven if it is not working properly.
• Outer Cabinet & Lamp Access: Never remove the outer
cabinet. This would be very dangerous due to high
voltage parts inside which must never be touched, as
this could be fatal, As your oven is not fitted with a
lamp access cover, if the lamp fails. Do not attempt to
replace the lamp yourself, call a Service Technician
appointed by SHARP.
When oven is working, air circulates within the cavity. The door does not
form an airtight seal so air may escape from the door.
The oven cavity will normally be colder than the food being cooked, and so
steam produced when cooking will condense on the colder surface. The
amount of steam produced depends on the water content of the food being
cooked. Some foods, such as potatoes have a high moisture content. Con-
densation trapped in the door glass should clear after a few hours.
Arcing will occur when a metallic object comes into dose proximity to the
oven cavity during cooking. This may possibly roughen the surface of the
cavity, but would not otherwise damage the oven.
Ensure all "eyes" are removed and place in a heat resistant flan dish or
similar.
Check the door is closed properly.
Ensure correct power level has been selected.
The microwave energy pulses ON/OFF during cooking/defrosting.
The cabinet may become warm to the touch - keep chidren away
POSSIBLE CAUSE
Draught circulates around the
door.
Condensation forms in the
oven, and may drip from the
door.
Flashing or arcing from within
the cavity when cooking.
Arcing potatoes.
After setting the time, the
oven does not start.
Oven cooks too slowly.
Oven makes a noise.
Outer cabinet is hot.
PROBLEM
! WARNINGS: