Sanyo PDP-32H1EN - Manual (Page 17)

17
BEFORE OPERATION
OPEN OPEN
1 2 3
Slide the lid
upward. Press the lid
downward
and slide it.
Remove the battery
compartment lid. Slide 2 batteries into
the compartment. Replace the compartment
lid.
REMOTE CONTROL BATTERIES INSTALLATION
Two AA size batteries
For correct polarity (+ and –), be sure
the battery terminals are in contact
with pins in the compartment.
WIRED REMOTE CONTROL OPERATION
Remote Control Cable (supplied)
To insure safe operation, please observe the following precautions :
● Use (2) AA, UM3 or R06 type alkaline batteries.
● Replace two batteries at the same time.
● Do not use a new battery with a used battery.
● Avoid contact with water or liquid.
● Do not expose Remote Control Unit to moisture, or heat.
● Do not drop Remote Control Unit.
● If batteries have leaked on Remote Control Unit, carefully wipe the case clean and load new
batteries.
When using this Remote Control Unit as Wired Remote
Control, Connect Remote Control Unit to R/C JACK with
Remote Control Cable (supplied). Batteries installation is
required when using as Wired Remote Control Unit.