Sanyo PDP-32H1EN - Manual (Page 21)

21
OFF TIMER
F
STATUS MOVE DOWN
OK
OFF
ON
POWER
MENU
POWER
ON
button
WHEN USE MULTIPLE MONITORS
When you use multiple Plasma Monitors, you can use POWER ON
button and POWER OFF button on Remote Control Unit instead of the
POWER ON-OFF button.
Press POWER ON button to turn Plasma Monitor ON so as not to
affect another Plasma Monitor which may be already turned ON.
Press POWER OFF button to turn Plasma Monitor OFF (standby
mode) so as not to affect another Plasma Monitor which may be
already turned OFF (standby mode) .
POWER
OFF
button
MUTE
WIDE
INPUT
ON-OFF
VOLUME PC/RGB
COMPONENT
OFF TIMER
PICTURE MOVE UP
VIDEO
OFF
TIMER
button
The OFF TIMER can be set to turn the power off after 30, 60, 90 or
120 minutes.
Pressing the OFF TIMER button on the Remote Control Unit until
desired time is displayed.
TO CHECK THE REMAINING TIME:
To check the remaining time of OFF TIMER set, press OFF TIMER
button once. The remaining time displayed for few seconds.
When you select input signal, the remaining time is displayed below
the input mode.
TO CANCEL THE OFF TIMER:
Pressing the OFF TIMER button until the time "0" is displayed.
When remaining time reaches zero, "Off timer 0" appears for 10
seconds, then Plasma Monitor turns to OFF (standby mode).
Off timer
30 30 120 90 60 0
Off timer
58
Off timer
0
AV 1
58
BASIC OPERATION