Sterling Plumbing ADA Adaptable Bath and Wall Surrounds 7114 Series - Manual (Page 16)

3. Install the Rough Plumbing
Series
7114 and 7124
7115
A 15-1/4 ″ (38.7 cm) 16-1/4 ″ (41.3 cm)
B 10 ″ (25.4 cm) 9-1/4 ″ (23.5 cm)
NOTE: Provide access to all plumbing connections to simplify future maintenance.
Include access at the back of the plumbing wall whenever possible.
NOTE: The dimension shown for the shower elbow is a recommended height.
NOTE: 7114 and 7124 series models are designed to be used with a single handle
valve with an escutcheon cover not exceeding 7-3/4 ″ (19.7 cm) in width.
NOTE: The plumbing end wall cannot be installed with the spout pipe in place. Use
of an elbow fitting is recommended. Once the plumbing end wall is installed, the
spout pipe can be threaded or sweated into the elbow. Choose the appropriate elbow
fitting for your application based on your access needs. See illustration.
NOTE: To meet ADA requirements, install the piping as recommended in the
roughing-in illustration. For baths with wall surrounds, ensure that the planned valve
location will not interfere with the plumbing end wall structure.
Install the water supply pipes according to the faucet manufacturer’s instructions.
Cap the supplies and check for leaks.
Strap the supply lines to the stud framing.
Blocking/Arrêt/Bloque
Shower Elbow/Coude de douche/Codo de ducha
A B
Valve/Valve/Válvula
Spout Elbow
Coude du bec
Codo del surtidor
25" (63.5 cm)
Min/Min/Mín 25" (63.5 cm)
Min/Min/Mín
7114, 7124, 7115 Series
with "Through the Floor" Drain
Séries 7114, 7124, 7115
avec drain "A travers le sol"
Serie 7114, 7124, 7115
con desagüe "a través del piso" 7114, 7124, 7115 Series
with "Above the Floor" Drain
Séries 7114, 7124, 7115
avec drain "Au-dessus du sol"
Serie 7114, 7124, 7115
con desagüe "arriba del nivel del piso"
77"
(195.6 cm)
Min/Min/Mín 78"
(198.1 cm)
Min/Min/Mín
Blocking/Arrêt/Bloque
1065823-2-F 16 Sterling