SMC Networks SpacePC 1232 Series - Manual (Page 67)

67
67
Watchdog modalities
The watchdog function resets the board at the end of the countdown.
There are two ways to program the watchdog:
• Using
BIOS INT 52h
• Using
direct Super I/O registers programming
BIOS INT 52h - functions 0Ch, 0Dh, 0Eh
This method can be used under DOS or under Operating Systems using the board BIOS (i.e. not
under Linux which erases the BIOS after the boot and autonomously manage the module
hardware).
The functions implemented from the BIOS are:
INT 52h, function 0Ch:
watchdog enabling with a fixed time of 2 seconds. This function programs
and starts immediately the watchdog counter.
INT 52h, function 0Dh:
watchdog erasing. Counting is interrupted and watchdog disabled.
INT 52h, function 0Eh
: watchdog refresh. Every call to this function restarts the counting from the
initial value.
When the watchdog is activated, the countdown starts immediately. If no refresh occurs, when
the default timeout expires, the board reset is executed. So the watchdog must be enabled and
continuously refreshed, avoiding in this way the board reset.
Example:
...
MOV
AH, 0Ch
INT 52h ; Enable the watchdog (fixed timeout = 2 seconds)
...
Super I/O registers programming
This method must be used when the OS doesn’t manage the BIOS (i.e. Linux) or when a
personalized watchdog programming is required.
The following example shows how to change the Super I/O (SPIO) FDC 37B782 watchdog
registers:
; SPIO: enter in configuration mode ...
MOV DX, 03F0h ; SPIO Index Port