Sony STR-DG920 - Manual (Page 35)

35 US
Ge
tting Star
te
d
6: Preparing the receiver
and the remote
Connect the AC power cord (mains lead) to a
wall outlet.
Notes
• Before connecting the AC power cord (mains
lead), make sure that metallic wires of the speaker
cords are not touching each other between the
SPEAKERS terminals.
• Connect the AC power cord (mains lead) firmly.
Before using the receiver for the first time,
initialize the receiver by performing the
following procedure. This procedure can also
be used to return settings you have made to
their factory defaults.
Be sure to use the buttons on the receiver for
this operation.
1
Press POWER to turn off the
receiver.
2
While holding down TONE
MODE and 2CH/A.DIRECT,
press POWER to turn on the
receiver.
3
Release the TONE MODE and
2CH/A.DIRECT after a few
seconds.
After “CLEARING” appears on the
display for a while, “CLEARED !”
appears.
All the settings you have changed or
adjusted are reset to the initial settings.
Connecting the AC power cord
(mains lead)
FRONT A
L R
FRONT B
L R
SURROUND CENTER
L R
SURROUND BACK
L R
SPEAKERS
AC power cord (mains lead)
To the wall outlet
Performing initial setup
operations
SPEAKERS (OFF/A/B/A+B)
PHONES VIDEO 2 IN/PORTABLE AV IN
VIDEO L AUDIO R AUTO CAL MIC
MEMORY/ ENTER 2CH/ A.DIRECT A.F.D. MOVIE MUSIC DIMMER
MULTI CHANNEL DECODING
INPUT SELECTOR
TONE MODE
ON/STANDBY
TUNING MODE
POWER
TUNING
DISPLAY INPUT MODE
MASTER VOLUME
TONE
1,2
2,3 2,3