SUPER MICRO Computer I2DMR-8G2 - Manual (Page 38)

2-18
SUPER i2DMR-8G2/i2DMR-iG2 User's Manual
Power Fault
Connect a cable from your power
supply to the U62 header to pro-
vide warning of power supply fail-
u r e . T h i s w a r n i n g s i g n a l i s
passed through the PWR_LED pin
on U66 to indicate of a power fail-
ure on the chassis. See the table
on the right for pin definitions.
Note: This feature is only available when using
redundant Supermicro power supplies.
SMB
A S y s t e m M a n a g e m e n t B u s
header is located at J22. Connect
the appropriate cable here to uti-
lize SMB on your system.
Power Fault
Pin Definitions (U62)
Pin
Number
1
2
3
4
Definition
P/S 1 Fail Signal
P/S 2 Fail Signal
P/S 3 Fail Signal
Reset (from MB)
Alarm Reset
The system will notify you in the
event of a power supply failure.
This feature assumes that Super-
m i c r o r e d u n d a n t p o w e r s u p p l y
units are installed in the chassis.
If you only have a single power
supply installed, you should dis-
able this (the default setting) with
(CN5) to prevent false alarms.
S e e t h e t a b l e o n t h e r i g h t f o r
jumper settings. (The Alarm Re-
set header is located next to
t h e P W R F a u l t h e a d e r a n d
close to Fan3.)
SMB Header
Pin Definitions (J22)
Pin
Number
1
2
3
4
Definition
Data
Ground
Clock
No Connection
SMB Power (I 2 C)
Connector
I 2 C Connector (J27), located be-
tween the PWR ForceOn Header
and the PWR Fault header, moni-
tors the status of PWR Supply,
Fan and system temperature.
SMB PWR
Pin Definitions (J27)
Pin #
1
2
3
4
5
Definition
Clock
Data
N/A
N/A
N/A
Jumper
Position
Open
Closed
Definition
Enabled
Disabled
Alarm Reset Jumper
Settings
(CN5)