Sanyo MDF-593C - Manual (Page 6)

5
PRECAUTIONS FOR SAFE OPERATION
Select a level and sturdy floor for installation. This precaution will prevent the unit from tipping.
Improper installation may result in water spillage or injury from the unit tipping over.
Connect the unit to a power source as indicated on the rating label attached to the unit. Use
of any other voltage or frequency other than that on the rating label may cause fire or electric shock.
When removing the plug from the power supply outlet, grip the power supply plug, not the cord.
Pulling the cord may result in electric shock or fire by short circuit.
Never damage or break the power supply plug or cord. Do not use the supply plug if its cord
is loose. This may cause fire or electric shock.
Do not touch any electrical parts such as the power supply plug or any switches with a wet hand.
This may cause electric shock.
Make sure to check the setting temperature when starting up the operation after the power
failure or power off. A change of set temperature may cause damage to contents.
Do not put a container with water or heavy articles on the unit. It may cause injury if the articles
fall. Current leakage or electric shock may be resulted form the deterioration of insulation by spilled
water.
Do not climb onto the unit or do not put articles on the unit. This may cause injury by tipping or
damage to the unit.
Do not put glass bottles or cans into the compartment since they may be broken by frozen
contents and cause injury.
Put on dry gloves when you take out refrigerated articles from the freezer. Handing frozen
contents or the inside walls with naked hands may cause frostbite.
Do not defrost inside walls using a knife or ice pick. There are pipelines for cooling behind the
walls. Be careful not to damage the lines as this could cause a breakdown. Also, do not make a
hole in the wall for installation of attachments.
Always hold the handle when closing the door. This will reduce the likelihood of a trapped finger.
Check the filter mentioned in this manual and clean it as necessary. A dusty filter may cause
temperature rise or failure.
CAUTION