Sony CMT-J3MD - Manual (Page 16)

16
Press lm for the top side
during playback.
Press ML for the bottom
side during playback.
Each time you press the button,
the display shows the number of
tracks to be skipped.
Press ML for the top side
during playback.
Press lm for the bottom
side during playback.
Each time you press the button,
the display shows the number of
tracks to be skipped. Find the
succeeding
track (AMS*
3 )
2
Press FUNCTION repeatedly until
“TAPE” appears.
3
Press DIRECTION repeatedly until g
appears to play one side or h (or
j
* 2 ) to play both sides.
4
Press TAPE H.
The indicator on the TAPE H button lights
green, then the tape starts playing.
Press TAPE h to play the bottom side.
* 2 The tape deck stops automatically after repeating
the sequence five times.
To Do this
Stop play Press s.
Pause Press S TAPE. The indicator on
the S TAPE button lights
orange. Press again to resume
play.
Tips
• Pressing TAPE H or h when the system is off
automatically turns on the system and starts playing
a tape if there is a cassette in the system (
One
Touch Play ).
• You can switch from another source to the tape
deck and start playing a tape just by pressing TAPE
H or h (
Automatic Source Selection ).
• To listen to a tape recorded with the Dolby noise
reduction system, press DOLBY NR so “DOLBY
NR” appears in the display.
Note
The AMS feature may not work in the following
cases:
— the blank space between tracks is four seconds
or less.
— the sound source recorded on the right channel
is different from that on the left channel.
— low volume or low sound continues for a long
time.
— the TV is too close to the system.
Remove the
cassette
Playing a tape (continued)
Find the
preceding track
(AMS
*3 )
Fast-forward Press lm or ML in
stop mode.
Rewind Press lm or ML in
stop mode.
Press to open the cover of the
tape deck.
Adjust the volume Turn VOLUME.
* 3 The Automatic Music Sensor (AMS) feature
detects a blank space of more than four seconds
between tracks to locate tracks quickly.